Setup Guide — MDA 5V, 5SV, 5A RCA
The Extron® MDA 5 series of mini distribution amplifiers distribute buffered
composite video (MDA 5V), buffered S-video (MDA 5SV), and amplified stereo audio
(MDA 5A RCA). Unless otherwise stated, these instructions apply to all three of the
amplifiers.
These instructions provide a quick setup guide for experienced installers.
Installation and service must be performed by authorized personnel only.
W
Indicators and
Connectors
INPUT
OUTPUTS
MDA 5SV
3
POWER
12V
.5A MAX
3
4
Power LED
1
2
IN
HIGH Z
75 Ohm
a
1
Power supply input
b
c
d
DISTRIBUTION AMPLIFIER
LOOP
5
Video input
Front Panel All Models
Video loop to local
monitor
2
7
4
6
Rear Panel MDA 5SV
Audio input (left channel
top; right channel
bottom)
e
INPUT
OUTPUTS
MDA 5A RCA
MDA 5V
5
1
2
3
4
3
L
POWER
12V
.5A MAX
POWER
12V
.34A MAX
3
1
2
IN
HIGH Z
75 Ohm
High Z/75 Ohm switch
video outputs
f
g
h
R
4
5
INPUT
OUTPUTS
LOOP
audio outputs (left
channel top; right
channel bottom)
7
6
8
4
2
5
2
Rear Panel MDA 5V
Rear Panel MDA 5A RCA
Step 1
Turn all the equipment off and disconnect all cables.
Step 2
Mount the unit in a convenient location, in a rack, under a desk, or on a projector mounting system. Follow the
instructions included with the appropriate mounting kit.
POWER
12V
.5A MAX
Step 3
Connect the external 12 VDC power supply (provided) to the 2-pole, captive screw power
connector ( ). When power is applied to the unit, the front panel LED ( ) lights green.
b
a
Voltage polarity is important. Identify the negative lead by the ridges on the side (see figure
at right).
C
Always use a power supply specified by Extron for this unit. Use of an unauthorized power
supply voids all regulatory compliance certification and may cause damage to the supply
and the distribution amplifier.
C
Smooth
Ridges
A
A
SECTION A–A
Power Supply
Output Cord
Step 4
For the MDA 5V:
Connect a video source to the video input ( ), using composite video (BNC) connectors.
c
For the MDA 5SV:
Connect a video source to the video input ( ), using S-video (4-pin mini DIN) connectors.
c
For the MDA 5A RCA:
Connect an audio source to the audio inputs ( ), using unbalanced stereo to RCA connectors. Left channel input goes to
c
the upper input; right channel input goes to the lower input.
|
Eiki Projector EIP 250 User Manual
Extron electronic Stereo System STP24LC User Manual
Fender Stereo System Micro Compre User Manual
Fisher Paykel Refrigerator RX611DUX User Manual
Fisher Price Hearing Aid H4609 User Manual
FoodSaver Food Saver V325 User Manual
GE Air Conditioner AEE08 User Manual
GE Microwave Oven 900 Watts JVM1430 User Manual
Generac Power Systems Fan OG 2697 User Manual
Global Machinery Company Cordless Saw TRM18V User Manual